This is where you talk about the NXJ hardware related topics such as the brick, sensors, LEGO pieces, etc.
4 posts • Page 1 of 1
No you can't connect two motors to a single port and have it work. There are motor mux devices out there - which connect to a sensor port - not sure if they would work for you, they are complex and relatively expensive. The Ev3 has 4 motor ports...
gloomyandy wrote:The Ev3 has 4 motor ports...
Yes, I am thinking about it, but not clear on the status of lejos. Am I able to run NXT motors and the Hitechnic gyro from the EV3, via lejos/Java?
Yes you are, but please note that all of this stuff is very new. So if this is for any sort of time critical project (like a University project etc.), then using the EV3 may not be the best way to go...
Who is online
Users browsing this forum: No registered users and 2 guests