I have a program running on my pc which sends motor controls to the robot using BTsend and BT recieve. All was working well until i lost my bluetooth dongle and replaced it with a new one. It now wont make a connection. The following is displayed in the console:
BlueCove version 2.1.0 on winsock
Failed to open connection to the NXT
BlueCove stack shutdown completed
I have tried removing the robot from my list of bluetooth devices and repaired the robot again and still no luck. Do i need to change any setting anywhere as the com port may have changed?
This is where you talk about the NXJ software itself, installation issues, and programming talk.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: Baidu [Spider] and 3 guests