This is where you talk about the NXJ software itself, installation issues, and programming talk.
2 posts • Page 1 of 1
I have got the Tune sample to work fine but when i try to run the R2MeToo code that I typed up as per the book, it just stops, not sure if its a coding problem or if its trying to run or personally iI think its just turning off.. Any help or suggestions?
It is better to download the code from the book's website rather than typing it in. Check your batteries have sufficient power. If you have motors connected to B and C your robot should start moving forwards when you run the program. Does it do this? If the NXT has shut down, pressing the orange (ENTER) button will start it up again. You can use this as a test of whether it has shut down. If you press the Orange and gray rectangle buttons together (ENTER + ESCAPE) and the NXT is still running you will see a line across the LCD display and the NXT will shut down. This shows that it was still running.
Who is online
Users browsing this forum: No registered users and 2 guests