How many times I can replace the NXT firmware?

This is where you talk about the NXJ hardware related topics such as the brick, sensors, LEGO pieces, etc.

Moderators: imaqine, 99jonathan, roger

Posts: 56
Joined: Sat Sep 25, 2010 6:10 am

How many times I can replace the NXT firmware?

Postby unroller » Tue Oct 05, 2010 7:02 am

I have found a document from Brian Bagnall that contains a warning:
There is a theoretical limit to the number of times you can replace the firmware on your NXT before it wears out. Every time you replace the firmware, a piece of data called a lock bit is used up. This bit is rated to work 100 times (minimum) before it expires.

Does anybody know how this mechanism works? Is it a hardware limitation? I know that NXT built-in flash memory has limit to 10000 write operations. But I don't know reasons why NXT firmware cannot be replaced more than 100 times. What is the "lock bit" mentioned above?

New User
Posts: 8
Joined: Sat Dec 05, 2009 10:17 am

Postby Lauwenmark » Tue Oct 05, 2010 4:56 pm

John Hansen said this on another forum:
Reloading the firmware on the NXT eats up a cycle of the firmware flash page lock bits on the first two flash pages. These lock bits are rated at 100 cycles but very reliable sources have said that ATMEL has measured lock bit cycles as high as 7500. I also know that someone from LEGO has tested reflashing his NXT repeatedly until it failed. He was able to reflash somewhere around 7000-8000 times (I forget the exact number).

So it is safe to say that you shouldn't really be worried about reflashing your NXT brick multiple times. The rating of "100 cycles" of rewriting is a very conservative figure - the real value is likely to be a magnitude higher.

Active User
Posts: 123
Joined: Sun Jan 17, 2010 12:15 am
Location: Sophia-Antipolis (France)

Re: How many times I can replace the NXT firmware?

Postby epascual » Tue Oct 12, 2010 8:38 pm

unroller wrote:What is the "lock bit" mentioned above?

Lock bits (and fuse bits) are special pieces of harware used to configure ATMEL micro-controllers.

You can find documentation about them in the datasheets of ATmega series MCU for instance (the main ARM core of the NXT is seconded by an ATmega8 which deals with basic stuff such as IOs if I'm not mistaken)
Eric PASCUAL - POBOT association VP & co-founder -

Return to “NXJ Hardware”

Who is online

Users browsing this forum: No registered users and 3 guests