To avoid needing tweezers to get your micro-SD card out of EV3, put a piece of tape on the SD, and cut it such that it fits right in the SD slot. It will fit in a SD-to-microSD adapter as well. And it becomes very easy to take it out of your robot.
The Micro-SD with tape in the EV3:
And without a robot attached:
It even fits in a micro-SD-SD adapter:
This is where you talk about the EV3 hardware related topics such as the brick, sensors, LEGO pieces, etc.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests